Ultra Grey Gasket Maker is a premium choice for rigid joints that experience high torque loads.
-65degF to 500degF (-54degC to 260degC) intermittent.
Directions: 1. For best results, surfaces should be clean and dry. 2. Cut nozzle and apply a continuous 1/16" to 1/4" (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 3. Let dry for one hour then tighten to torque specifications. 4. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. Replace cap after use. Precautionary Statements—Storage: Store in a well-ventilated place. Keep container tightly closed. Store locked up.
Precautionary Statements—Disposal: Dispose of contents/container to an approved waste disposal plant.
Note: Not recommended for use on head gaskets or parts in contact with gasoline. WarningCauses serious eye irritation.May cause allergic skin reaction. Precautionary Statements—Response: If in Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: get medical advice/attention. If on Skin: Wash with plenty of soap and water. If skin irritation or rash occurs: get medical advice/attention. Wash contaminated clothing before reuse. Precautionary Statements—Prevention: Contains 2-butanone oxime. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Avoid breathing dust/fume/gas/mist/vapors/spray. Use personal protective equipment as required. Wash face, hands and any exposed skin thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. Keep out of reach of children.
Ultra Grey Gasket Maker is a premium choice for rigid joints that experience high torque loads.
-65degF to 500degF (-54degC to 260degC) intermittent.
Directions: 1. For best results, surfaces should be clean and dry. 2. Cut nozzle and apply a continuous 1/16" to 1/4" (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 3. Let dry for one hour then tighten to torque specifications. 4. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. Replace cap after use. Precautionary Statements—Storage: Store in a well-ventilated place. Keep container tightly closed. Store locked up.
Precautionary Statements—Disposal: Dispose of contents/container to an approved waste disposal plant.
Note: Not recommended for use on head gaskets or parts in contact with gasoline. WarningCauses serious eye irritation.May cause allergic skin reaction. Precautionary Statements—Response: If in Eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: get medical advice/attention. If on Skin: Wash with plenty of soap and water. If skin irritation or rash occurs: get medical advice/attention. Wash contaminated clothing before reuse. Precautionary Statements—Prevention: Contains 2-butanone oxime. Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Avoid breathing dust/fume/gas/mist/vapors/spray. Use personal protective equipment as required. Wash face, hands and any exposed skin thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. Keep out of reach of children.